Download Philips MCD515 User's Manual

MCD515
Quick Start Guide
What’s in the Box?
You should find these items upon opening the box.
Quic
1
k St
art
Guid
e
Composite Video Cable
Quick Start Guide
Remote control with two
AA batteries
PRO
2
User Man
ual
MW antenna
MCD515 QUG_Eng
FM antenna
1
User Manual
2006.4.26, 9:42
1
Connect the speaker cables.
2
Connect the MW and FM antennas.
Tip
3
See the User Manual for other TV
connection options.
Connect the composite video cable to a TV.
4
Connect the power cords of the system and TV.
AUDIO
IN
S-VIDEO
IN
Cr
Cb
VIDEO IN
FM wire
antenna
MW loop
antenna
Y
AUDIO
IN
S-VIDEO
IN
3
TV IN
VIDEO IN
2
DIGITAL
OUT
Speaker
(right)
R
LINE OUT
Speaker
(left)
L
R
L
AM ANTENNA
FM ANTENNA
AUX/
CDR IN
SUB
WOOFER OUT
+
R
L
1
+
SPEAKERS 8Ω
4
AC power cord
Setting up the TV
ANGLE
A-B
1
Press SOURCE (DISC on the remote) to select disc source.
IS
2
Turn on the TV and set it to the correct Video In channel.
MCD515 QUG_Eng
2
2006.4.26, 9:43
DSC
MODE
PROGRAM
Setting the clock
1
5
In standby mode, press and hold CLOCK SET on the system.
2
When the hour digits flash, turn the VOLUME control on the front panel or press VOL+/on the remote to set the hours.
3
Press CLOCK SET again and the minute digits flash. Then turn the VOLUME control on
the front panel or press VOL+/- on the remote to set the minutes.
4
Press CLOCK SET again to confirm the time setting.
Setting system menu options
ITALIAN
DIVX(R) VOD
MIC SETUP
Tip
See chapters "Preparations" and "System Menu Options" in the User
Manual for detailed descriptions.
MCD515 QUG_Eng
3
2006.4.26, 9:43
PRESET
TUNING
T H E AT H R E
Playing a disc
1
Press OPEN•CLOSE3 to open the disc tray and load in a disc, then press the same
button again to close the disc tray.
➜ Make sure the label side of the disc is facing up.
OPEN • CLOSE
2
Playback will start automatically. If not press PLAY/PAUSEÉÅ.
3
To stop playback, press STOP 9.
RECORD
STANDBY-ON
BAND
CLOCK SET
DISPLAY
RDS
iR
Programming and tuning to radio stations
1
Press SOURCE (TUNER on the remote) to select tuner source.
2
Press PROGRAM for more than three seconds to program all available stations in order
of waveband.
3
Press PRESETí/ë until the desired preset station is displayed.
Tip
Detailed playback features and additional functions are described in the
accompany owner's manual.
2005 C Koninklijie Philips Electronics
N.V. All rights reserved.
http://www.philips.com
MCD515 QUG_Eng
4
PDCC-JS/JW-0616
2006.4.26, 9:43