Download Perle Systems Switch DS1 User's Manual

Serial Port Profiles
Success String
String that is sent to the serial device when a connection succeeds.
Default: CONNECT <speed>, for example, CONNECT 9600
Failure String
String that is sent to the serial device when a connection fails.
Default: NO CARRIER
Numeric Codes
When enabled, the connection status is sent to the connected device using the
following numeric codes:
z
1 Successfully Connected
z
2 Failed to Connect
z
4 Error
Default: Enabled
Advanced Tab Field Descriptions
Configure the following parameters:
Echo characters in When enabled, echoes back characters that are typed in (equivalent to
command mode
ATE0/ATE1 commands).
Default: Disabled
DTR Signal Always Specify this option to make the DTR signal always act as a DTR signal.
On
Default: Enabled
DTR Signal Acts as Specify this option to make the DTR signal always act as a DCD signal.
DCD
Default: Disabled
DTR Signal Acts as Specify this option to make the DTR signal always act as a RI signal.
RI
Default: Disabled
RTS Signal Always Specify this option to make the RTS signal always act as a RTS signal.
On
Default: Enabled
101