Download PASCO Specialty & Mfg. ET-8783 User's Manual
Transcript
Model No. ET-8783 012-08761-A Energy Transfer - Wind Turbine Model No. ET-8783 Equipment List 1 ET-8771 not included 2 Included Equipment Replacement Model Number* 1. 5-Blade Fan 550-023 2. Thumb Nut 614-006 3. Spacer (hidden from view) 615-046 *Use Replacement Model Numbers to expedite replacement orders. Additional Equipment Required Energy Transfer Generator ET-8771 1 Energy Transfer - Wind Turbine Model No. ET-8783 Introduction The Energy Transfer - Wind Turbine accessory can be attached to the Energy Transfer Generator (ET-8771) to create a wind energy turbine. Equipment Setup Energy Transfer-Wind Turbine Assembly 1. Remove the thumb nut and pulley from the Energy Transfer Generator. Do not discard these components. Retain for other use. 2. Place spacer over plastic shaft of the Energy Transfer-Generator. 3. Place 5-blade fan over same plastic shaft of Energy Transfer Generator. 4. Note orientation of 5-blade fan. See Figure 1. 5. Secure 5-blade fan with thumbnut. Do not over tighten. do not discard ET-8771 (not included) thumbnut spacer 5-blade fan Figure 1: Wind Turbine Assembly 2