Download NEC Express5800/R120f-1M User Guide

Transcript
Step 4
Click [Next]. The [Check the contents, and
completing the "Create SSD Cache Drive" Wizard]
window appears.
The window shows the contents of SSD Cache Drive to
be created.
To create an SSD Cache Drive with the settings
displayed, click [Finish]. To change the settings , click
[Back].
Click [Finish] to create an SSD Cache Drive and close
the wizard. After the wizard closes, see the Tree View
to check the contents.
Click [Back] to cancel the creation of SSD Cache Drive.
raidcmd
Step 1
required.
Connect Solid State Drive(s) used for an SSD Cache Drive to the RAID Controller before executing raidcmd if
Step 2
Execute "mkscd" command with following
parameters.
-c : Number of RAID Controller in which an SSD Cache
Drive is created.
-p : Numbers of the Physical Device(s) used for creating of
SSD Cache Drive.
> raidcmd mkscd –c=1 –p=e252s6,e252s7
raidcmd creates SSD Cache Drive #2
Do you continue ? [yes(y) or no(n)] : yes
2
3
raidcmd created SSD Cache Drive #2.
>
Ex) Create SSD Cache Drive using the Solid State
Drives (RAID Controller Number is 1, Physical Device
Number is e252s6, e252s7).
raidcmd mkscd -c=1 -p= e252s6,e252s7
Step 3
Display the confirmation message. Type "yes" to create an SSD Cache Drive. Type "no" to cancel the creation
of SSD Cache Drive.
Step 4
raidcmd terminates normally when SSD Cache Drive is created successfully. You can check the property of
the created SSD Cache Drive by using "property" command.
88