Download Kenmore Elite 30'' Range Hood Installation Guide

Run power cable to installation location. Place the hood
at its location. Using a pen, mark the position of the
screws (smaller part of the key holes). Remove the hood
and install the (8) 1/2" double thread screws leaving
a 1/8" gap (4 screws for 30" hood). Remove wiring
cover and set aside. Place the wire clamp, insert the
hood and tighten the wire clamp to secure the cable.
Place the hood under the cabinet and slide it in position.
Make sure the adapter enters the ductwork. Secure the
hood by tightening the screws completely.
_
with all appllcable
WARNING:
Risk of electrical
codes andshock.
standards.
Electrlcal
Before
wiringconnecting
must be done
wires,byswitch
qualified
power
personnel
off at in
service
accordance
panel
and lock service disconnecting means to prevent power from being switched on accidentally.
1. Connect cable to wiring box using
Connect
BLACK to BLACK, WHITE
GREEN wire under second ground
wiring cover. DO NOT FORGET TO
GROUND.
wire connectors.
to WHITE, and
screw. Reinstall
CONNECT
THE
_E0008
1) Ground
screw
l
i
i
i <