Download JVC TH-A25 User's Manual

Connecting the FM and AM Antennas
If AM reception is poor, connect single vinyl-covered
wire (not supplied).
2
1
3
AM Loop antenna
(supplied)
If FM reception is poor, connect
outdoor FM antenna (not supplied).
Snap the tabs on the loop into
the slots of the base to
assemble the AM Loop
antenna.
FM antenna (supplied)
DIGITAL IN
AUDIO IN
CENTER
OPTICAL
RGB
COMPOSITE
L
L
R
R
FRONT
WOOFER
REAR
FRONT/CENTER
MIN 6
REAR
MIN 6
AUX
IMPEDANCE
WOOFER:MIN 3
Center unit
Cooling fan
(See “About the cooling fan” below.)
FM antenna connection
AM antenna connection
Connect the supplied FM antenna to the COAXIAL FM 75 Ω
terminal as temporary measure.
Extend the supplied FM antenna horizontally.
• If reception is poor, connect an outdoor antenna. Before attaching
a 75 Ω coaxial cable (with a standard type connector), disconnect
the supplied FM antenna.
Connect the supplied AM Loop antenna to the AM and H terminals.
Turn the loop until you have the best reception.
• If reception is poor, connect an outdoor single vinyl-covered wire
to the AM terminal. (Keep the AM Loop antenna connected.)
Notes:
If the AM Loop antenna wire is covered with vinyl, remove
the vinyl by twisting it as shown in the diagram.
About the cooling fan
A cooling fan is mounted on the rear panel of the center unit to
prevent abnormal temperature inside the center unit, thus assuring
normal operation of the unit. The cooling fan automatically starts
rotating to intake external cool air when the internal temperature
goes up.
For safety, observe the following carefully.
• Make sure there is good ventilation around the center unit. Poor
ventilation could overheat and damage the center unit.
• DO NOT block the cooling fan and the ventilation openings or
holes. (If they are blocked by a newspaper or cloth, etc., the
heat may not be able to get out.)
• DO NOT touch the speaker cords to the cooling fan.
5
01_09_TH_A25[B].p65
5
03.7.28, 8:05 PM