Download Intel Personal Computer NetStructure Single Board Computer User's Manual

Serial Over LAN (SOL)—MPCBL0010 SBC
reference_cfg: Success
cmmget -l blade14 -t raw
reference_cfg: Success
cmmget -l blade14 -t raw
reference_cfg: Success
cmmget -l blade14 -t raw
reference_cfg: Success
cmmget -l blade14 -t raw
reference_cfg: Success
11.8.2
-d "0x0C 0x21 1 0x03 0x07 0x2A"
-d "0x0C 0x21 1 0x04 0x03 0x0A"
-d "0x0C 0x21 1 0x05 0x06"
-d "0x0C 0x21 1 0x06 0x06"
Client Blade Setup
The client blade is the SOL blade that activates SOL on the target and receives serial
output from the target. The output is displayed on the client console.
Ensure the MPCBL0010 SBC has the following firmware/OS versions loaded:
• IPMC Firmware 4.56_R006 or later
• Bios 045.P04 or later
• sbcutilities 1.2.0.10 or later
• MontaVista 4.0 LSP,
RedHat RHEL 4.0 U3
Note:
ipmitool needs to be installed on a Linux computer located anywhere in the network.
In this example, ipmitool is running on another blade in the same chassis.
11.8.2.1
Configure the Ethernet Port
For MontaVista* 4.0:
1. Configure the IP address of the Ethernet port:
vi /etc/network/interfaces
auto lo ethN
iface lo inet loopback
auto ethN
iface ethN inet static
address 192.168.0.42
network 192.168.0.0
netmask 255.255.255.0
broadcast 192.168.0.255
gateway 192.168.0.1
2. Execute this command to restart the network:
/etc/init.d/networking restart
For RedHat* RHEL:
1. Configure IP address of the Ethernet port:
vi /etc/sysconfig/network-scripts/ifcfg-ethN
ifcfg-eth4
BOOTPROTO=static
IPADDR=10.90.90.113
NETMASK=255.0.0.0
ONBOOT=yes
TYPE=Ethernet
DHCP_HOSTNAME=rhel4u3
2. Execute this command to restart the network:
service network restart
October 2006
Order Number: 304120
Intel NetStructure® MPCBL0010 Single Board Computer
Technical Product Specification
157