Download HP D2D2502i CLI Reference Guide

config restore devices
Description of Command Function
Restores the StoreOnce system devices to the condition detailed in the defined device’s configuration
file.
NOTE: For more information about the configuration save and restore process, see the HP
StoreOnce Backup System User Guide (single-node or multi-node, depending on your product).
See also “config save devices” (page 22).
Command Syntax
config restore devices SETX[,X] ConfigFile force
Command Authority
Administrator
Command Object Requirements
Not applicable – no objects exist within this command.
•
ConfigFile – This required object defines the device configuration file detailing the configuration
to which the devices in the system are restored.
•
SETX – This required object defines the service set to which the drive will be added. X is the
numeric index of the service set. You can include more than one service sets.
Command Parameter Requirements
force – This optional parameter overrides any digital signatures or sumchecks.
Requirements for Command Execution
•
The command entry must conform to the command syntax.
•
All object values must be valid; see the object descriptions for details.
•
The parameter value must be valid; see the parameter description for details.
Successful Command Output
Upon successful completion of the command, the following is displayed:
Command Successful
Command Operation during Abnormal Conditions
•
20
If any of the command execution requirements fail, command execution terminates. The
configurations are not restored and one of these error messages is displayed:
◦
Command Failed - the command does not conform to the required
syntax, SYNTAX, where SYNTAX is the command syntax as described under Command
Syntax in this section.
◦
Command Failed – The configuration file does not exist
◦
Command Failed – The configuration file is not a device
configuration file
◦
Command Failed – Duplicate service sets
◦
Command Failed – The service set(s) are invalid
◦
The software version of the configuration file [configuration
software version] does not match system software version [system
software version]
◦
Command Failed – The system hardware does not match the
configuration file (difference in number of nodes)
Alphabetical List of Commands and Details