Download Graco 333347F User's Manual

Appendix A - ADM
Appendix A - ADM
General Operation
Icon
Description
ADM Power
Select channel to view and/or edit
the applicator or hose temperature
setting
The ADM automatically turns on when the main power
switch is turned ON.
Applicator temperature setting.
Screen Navigation
Use
ting.
To switch between the Setup and Operation screens,
press
. Use
,
,
, and
and
to adjust set-
Hose temperature setting.
to navigate
Use
ting.
between screens.
Enable, Disable Heating System
and
to adjust set-
Use to adjust temperature settings
To enable or disable the entire heating system,
press
. To set which channels are active when the
heating system is enabled, use the System 2 screen.
See page 117.
Icon Identification
Icon
Description
Operation Screens Only
Temperature settings of applicator
(top) and hose (bottom)
Reset weight total
Setup Screens Only
Enter screen to change settings
Heating disabled
Warming up, actual temperature is below setting
Temperature setting achieved
Actual temperature of hose
(left) and applicator (right)
Exit screen
Reset Maintenance error
Schedule Screen Only
Edit schedule value
Erase schedule value
Actual temperature of system
(shown warming up)
Accept schedule change
System temperature setting.
Cancel schedule change
Use
and
to adjust setting.
Use the physical numeric keypad on ADM to enter temperature setting.
114
333347F