Download Garmin Software Version 0719.00 Cockpit Reference Guide

SECTION 10 – HAZARD
AVOIDANCE
5) If desired, readjust the Bearing Line as discussed
previously to change the center of the Sector
Scan.
6) Select the BRG Softkey again to remove the Bearing
Line and cursor. The bearing reference is also reset
to 0º.
Figure 10-42 Selecting Sector Scan Position
2) Turn the small FMS Knob to place the Bearing Line
in the desired position. The location of the Bearing
Line becomes the center point of the Sector Scan.
3) Turn the large FMS Knob to place the cursor in the
SECTOR SCAN field.
4) Turn the small FMS Knob to select FULL, 60˚, 40˚,
or 20˚ scan.
Figure 10-43 40˚ Sector Scan
Antenna Stabilization
1) To activate or deactivate the antenna stabilization,
select the MODE Softkey.
2) Select the STAB ON Softkey to activate antenna
stabilization or select the STAB OFF Softkey to
deactivate. The current stabilization condition is
shown in the upper right of the weather radar
display.
190-00708-00 Rev. A
Garmin G1000 Cockpit Reference Guide for the Socata TBM 850
10-27