Download Garmin Software Version 0552.14 Cockpit Reference Guide

Transcript
Appendix
Flight
Instruments
13) Turn system power OFF.
14) Remove the SD card from the top card slot of the MFD.
15) Turn system power ON.
EIS
16) Press the ENT Key to acknowledge the startup screen.
17) Turn the large FMS Knob to select the AUX Page group on the MFD.
Nav/Com/
XPDR/Audio
18) Turn the small FMS Knob to select the System Status Page.
GPS Nav
19) Press the Display Database Selection Softkey to show standby navigation
database information for each display (MFD1 DB, PFD1 DB, PFD2 DB).
Verify the correct standby navigation database cycle information is shown
for each display.
Magnetic Field Variation Database Update
Flight
Planning
Procedures
Hazard
Avoidance
At startup, the system compares this version of the MV DB with that presently being
used by each AHRS (GRS1 and GRS2). If the system determines the MV DB needs
to be updated, a prompt is displayed on the Navigation Map Page, as shown in the
following figure. Note, in the following example, GRS1 is the first AHRS to indicate
an update is available. In actuality, this is dependent on which AHRS is the first to
report status to the system. GRS2 may be displayed before GRS1. The order is not
important, only that both AHRS be updated.
Additional
Features
Abnormal
Operation
GRS1 Magnetic Field Variation Database Update Prompt
Annun/Alerts
Loading the magnetic field variation database update:
1) With ‘OK’ highlighted, as shown in the previous figure, press the ENT Key
on the MFD. A progress monitor is displayed as shown in the following
figure.
Appendix
Index
190-00645-05 Rev. A
Garmin G1000 Cockpit Reference Guide for the Quest KODIAK 100
103