Download Franklin RBI-100 User's Manual
Transcript
RBI-100 CALLER ID User’s Guide Mode d’emploi • Manual del usuario 40 Introduction Congratulations! You now own a Rolodex® Electronics Caller ID. Your Caller ID can: • store up to 90 call records, including information such as caller’s name, and/or phone number, and the time the call was placed, if available, • alert you when new calls have been received, • display the current time and date, • display the total number of calls received, • display prompts and screen displays in one of three languages: English, French, or Spanish, • alert you when you have messages waiting, if you have a voice mail service from your phone company, and • be used on a desktop or be mounted on a wall. Important! To operate your Caller ID, you must first contact your phone company and order Caller ID service. There is a charge for Caller ID service, which will appear on your monthly phone bill. Caller ID service may not be available in all areas. 1 Introduction ® New Call Indicator Light New Message Indicator Light NEW MSG REVIEW SET DEL Down Delete Up Set Battery Compartment Door Wall Mount Wall Mount Phone Jack and Line Jack (Interchangeable) 2 Getting Started To Install the Battery (Not Included) Note: The Caller ID will not function without a battery. 1. Disconnect the telephone line. 2. Lift the battery compartment door on the back of the Caller ID. 3. Install a 9-volt battery. 4. Replace the battery compartment door. To Connect the Telephone Line 1. Connect one end of the telephone cord into one of the jacks on the back of the Caller ID (either jack can be used) and connect its other end into the wall jack. 2. Connect one end of the included telephone cord into the other jack on the Caller ID and connect its other end into your telephone. 3. If desired, use two anchor screws to mount your Caller ID on a wall. 3 Changing the Settings Caution: When you press SET to change a setting, that setting will flash on the screen for about 5 seconds. If you do not adjust the setting and then press SET during this time, the settings will remain unchanged. To Set the Time and Date 1. Press SET until ENTER TIME appears and the hour is flashing. or to adjust the hour. 2. Use You can also adjust AM and PM on the 12-hour clock while adjusting the hour. Note: When the language is set to English, the clock is a 12-hour clock which can be set to AM or PM. When the language is set to French or Spanish, the clock is a 24-hour clock. 3. To set the minutes, press SET until ENTER TIME appears and the minutes are flashing or . and then use 4. To set the month, press SET until ENTER DATE appears and the month flashes, and or . then use 5. To set the day, press SET until ENTER DATE appears and the day flashes, and or . then use If you do not want to set the language or area code, wait 5 seconds for the flashing to stop. 4 Changing the Settings To Set the Language and Area Code 1. To set the language of the screen prompts, press SET until IN ENGLISH? appears. 2. Use or to set a language. 3. To set your area code, press SET until ENTER AREA CODE appears and the first digit of the area code flashes. or to change the first digit. 4. Use 5. To change the other digits, press SET until the or . desired digit flashes and then use Note: If your area code has three digits, press SET again when the fourth digit flashes. After you have set the area code, your Caller ID displays the current date and time. 4-11 AM 10:30 5 Receiving Calls When the telephone connected to the Caller ID rings, new call information appears between the first and second ring. If you answer before the second ring, the Caller ID will not display any information. When a call is received, the Caller ID displays a call record, which can include, if available, the name of the caller, the caller’s telephone number, and the time that the call was placed. The amount of information displayed depends on the signal sent by your phone company. 4-11 PM 1:30 NEW # 609-555-1026 03 JOHN SMITH If the call is from outside your phone company’s area, some of the caller’s information may not be available and UNKNOWN NAME and/or no number may be displayed. The NEW Call Indicator Light will flash for about 15 seconds after a new call is received. If the caller’s name or number is blocked by the caller, that information will not be displayed. 6 Reviewing Calls This Caller ID automatically stores the call information from the last 90 calls. If you have not received any new calls, the Caller ID will display the date, time, and number of total calls, if any. If you have received new calls, the screen will display the appropriate number (ex: 03 NEW CALLS). 4-11 PM 4:27 NEW ONE NEW CALL 1. To review your new calls, press repeatedly. 2. To review your old calls, press repeatedly. When you reach the end or top of the list, press the opposite direction key to cycle back through your call records. 7 Reviewing Calls ✓ About Message Waiting Your Caller ID can alert you to check your phones messages if you have a voice mail service from your phone company that offers Caller ID signalling. For more information about these services, contact your phone company. When you have a new message, the phone company will send a signal to your Caller ID that causes the MSG light to blink and a marker to appear on the display the next time you receive a call. After your messages are reviewed, the phone company sends a signal to clear the display and stop the MSG light from blinking. ✓ About Repeat Calls Your Caller ID will save information from the same name and/or number, but will use only one call record to store the information. Each time a call is received from the same name and/or number, the time and date of the call record is updated and a REP marker appears near the time. ✓ About Toll Calls If your phone company’s service supports it, your Caller ID will display a toll call marker ($) to indicate that the call received is a toll call. 8 Deleting Calls To Delete Individual Calls When you are reviewing a call record, you can delete it from your Caller ID’s memory. 1. Use or to find the call record you want to delete. 2. Hold DEL for about 1 second. The call record will be deleted and the next call record will be displayed. To Delete All Your Calls 1. Use or until you see TOP OF LIST or END OF LIST. 2. Hold DEL until DELETE ALL? appears. Warning! If you continue with these steps all your call records will be deleted. 4-11 PM 5:07 DELETE ALL? DELETE ALL? is displayed for about 10 seconds. 3. To delete all your calls, hold DEL for about 1 second while DELETE ALL? is on the screen. Or press any other key to cancel. 9 Troubleshooting ✓ When the Battery Is Low When the battery is low on power, the low battery marker ( ) appears on the display. You should change the battery as soon as possible to ensure normal operation. Warning! Your call records may be erased if the Caller ID is without a battery for more than 20 seconds, so be sure to have a fresh battery on hand before you remove the old battery. To learn how to install a battery, read “Getting Started.” ✓ About Error Messages If ERROR appears while receiving call information, then that information is corrupted and may not appear on the display. ✓ Safety Instructions When using your Caller ID, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and/or injury to persons, including the following: • Follow all warnings and instructions marked on the product. • Do not use this product near water. • This product should never be placed near or over a radiator heat register. 10 Troubleshooting • To reduce the risk of electric shock, do not disassemble this product. Take it to a qualified serviceman when service or repair work is required. Opening or removing covers may expose you to dangerous voltages or other risks. Incorrect reassembly can cause electric shock when the appliance is subsequently used. • Unplug this product from the telephone lines and refer to qualified service personnel under the following conditions: A. If the product has been exposed to liquid. B. If the product has been dropped or the case has been damaged. C. If the product exhibits a distinct change in performance. • Avoid using during an electrical storm. There may be a remote risk of electric shock from lightning. • Never install telephone wiring during a lightning storm. • Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected from the network interface. 11 Limited Warranty (U.S. only) Franklin Electronic Publishers, Inc. (“Franklin”) warrants to the end user that this product will be free from defects in material and workmanship for a period of ONE YEAR from the date of original retail purchase, as evidenced by sales receipt. On discovery of a defect, the end user must return this product (transportation charges prepaid) either to the dealer from whom it was purchased or directly to Franklin at the address given below. Each product returned must include the user’s name, address, and telephone number, as well as a brief description of the nature of the defect and a copy of the sales receipt as proof of the date of the original retail purchase. Franklin will, at its option, repair or replace any product at no further charge to the end user on determination by Franklin, in its sole discretion, that the product was defective and that such defect arose within the duration of this limited warranty. Enclose $3.00 check or money order for shipping and handling to Franklin Electronic Publishers, Inc. This warranty does not apply if, in the sole discretion of Franklin, the product has been tampered with, damaged by accident, power surge, acts of nature, improper installation, negligence, abuse, misuse, or misapplication, or as a result of service or modification by any party, including any dealer, other than Franklin. FRANKLIN SHALL NOT BE RESPONSIBLE IN ANY WAY FOR ANY SERVICE OR MODIFICATION TO THIS PRODUCT BY ANY PARTY, INCLUDING ANY DEALER, OTHER THAN FRANKLIN. This warranty applies only to products manufactured by or for Franklin. Batteries, corrosion of battery contacts and any damage caused by batteries are not covered by this warranty. ALL IMPLIED WARRANTIES, INCLUDING ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, SHALL BE STRICTLY LIMITED IN DURATION TO THAT OF THE EXPRESS WARRANTY SET FORTH ABOVE, THAT IS, ONE YEAR FROM THE DATE OF ORIGINAL RETAIL PURCHASE. THE WARRANTY AND REMEDY SET FORTH ABOVE ARE THE EXCLUSIVE REMEDY OF THE RETAIL BUYER AND END USER IN CONNECTION WITH THE MANUFACTURE, SALE, OR USE OF THIS PRODUCT AND ARE IN LIEU OF ANY AND ALL OTHER WARRANTIES OR REMEDIES, WRITTEN OR ORAL, EXPRESS OR IMPLIED. NO FRANKLIN DEALER, AGENT, OR EMPLOYEE IS AUTHORIZED TO MAKE ANY ADDITIONAL WARRANTY IN THIS REGARD OR TO MAKE ANY MODIFICATION OR EXTENSION OF THIS EXPRESS WARRANTY. FRANKLIN SHALL NOT BE RESPONSIBLE FOR SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES RESULTING FROM THE BREACH OF ANY EXPRESS OR IMPLIED WARRANTY OR IN CONNECTION WITH THE MANUFACTURE, SALE, OR USE OF THIS PRODUCT UNDER ANY LEGAL THEORY, WHICH DAMAGES SHALL INCLUDE, BUT NOT BE LIMITED TO, LOST PROFITS, DAMAGES TO PROPERTY OR DAMAGES FOR PERSONAL INJURY (BUT ONLY TO THE EXTENT PERMITTED BY LAW). UNLESS OTHERWISE CONTRARY TO APPLICABLE LAW, FRANKLIN’S LIABILITY SHALL IN NO CASE EXCEED THE PRICE PAID FOR THE PRODUCT CLAIMED TO BE DEFECTIVE. This warranty shall not be applicable to the extent that the enforcement of any provision may be prohibited by applicable law. This warranty gives you specific rights, and you may also have other rights which vary from state to state. Some states do not allow the exclusion or limitation of incidental or consequential damages or limitation on how long an implied warranty may last so the above limitation or exclusion may not apply to you. Enclose $3.00 check or money order for shipping and handling to: FRANKLIN ELECTRONIC PUBLISHERS, INC. ATTENTION: SERVICE DEPARTMENT ONE FRANKLIN PLAZA BURLINGTON, NEW JERSEY 08016-4907 12 Product Information Specifications Model: RBI-100 • Dimensions: 111 x 67 x 70 mm • Weight: 4.7 oz. • REN 0.0B Cleaning, Storage, Problems To clean this Caller ID, spray a mild glass cleaner onto a cloth and wipe its surface. Don’t spray liquids directly on the Caller ID. Don’t use or store this Caller ID in extreme or prolonged heat, cold, humidity, or other adverse conditions. If you have a problem with your Caller ID, refer to the limited warranty. For sales and customer service, please call 1-800-266-5626. FCC Notice This device complies with part 68 of FCC Rules. This device complies with part 15 of FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference; and (2) this device must accept any interference received, including interference that may cause undesirable operation. Copyrights ©1997 Franklin Electronic Publishers, Inc. Burlington, N.J. 08016-4907 USA. All rights reserved. Rolodex® is a registered trademark of Newell Co. 13