1
Download Dish 20 User Guide
Transcript
Discrete Codes Discrete On and Off IR-only remote-control commands are used by installers when programming macro commands into universal remotes. Using an On-only or Off-only command is more effective than a toggle On/Off command when trying to ensure the receiver is reliably in one state or the other. Program the DISH Network remote to the desired remote address (see Changing the Remote and Receiver Address, page 29). 1 2 SAT Hold SAT until all Mode buttons light, then release the button. 3 Press POWER (not TV POWER). 4 Press VOLUME UP for discrete power on. Press VOLUME DOWN for discrete power off. 5 Press any other button when done to end this procedure. 28
