Download Dell 2707WFP User's Manual

Wrong Color
Image retention from a static image left on
the monitor for a long period of time
Picture color not
good
Faint shadow from
the static image
displayed appears
on the screen
l
Change the color to "PC Custom Color" or "MAC Custom Color"
Adjust R/G/B value of "PC Custom Color" or "MAC Custom Color"
Change the Color Format to "PC RGB" or "YPbPr" (for Video/DVI-HD inputs)
l
Use the Power Management feature to turn off the monitor at all times when not in use
l
Alternatively, use a dynamically changing screen saver
l
l
Video Problems
COMMON
SYMPTOMS
No Video
WHAT YOU EXPERIENCE
POSSIBLE SOLUTIONS
No signal indicator is displayed
l
Check Video Input Selection
¡ Composite: Yellow colored RCA jack
¡ S-Video: Typically a round 4 pin jack
¡ Component: Red, Blue, Green colored RCA jacks Low Quality DVD
playback
Picture not crisp and some color
distortion
l
Check DVD connection
¡ Composite gives good picture
¡ S-Video gives better picture
¡ Component: Red, Blue, Green colored RCA jacks
Blinking Video
Video is blinking or discontinuous
l
Check DVD connection
¡ Composite gives good picture
¡ S-Video gives better picture
¡ Component: Red, Blue, Green colored RCA jacks Check if DVD player is HDCP compliant.
¡ Some non-compliant players may exhibit blinking video and others will display a
raster scree
l
NOTE: When choosing S-Video, Composite or Component video, Auto Adjust function is not available.
Product Specific Problems
SPECIFIC SYMPTOMS
WHAT YOU EXPERIENCE
Screen image is too small
Image is centered on screen, but does not fill entire
viewing area
Cannot adjust the monitor with the OSD does not appear on the screen
buttons on the front panel
POSSIBLE SOLUTIONS
l
Perform monitor reset on "Factory Reset"
l
Turn the monitor off and unplug the power
cord and then plug back and power on
The monitor will not go into
power saving mode.
No picture, the LED light is green. When press “+”, “” or “Menu” key, the message “ No S-Video input
signal ”, “ No Composite input signal ” or “ No
Component input signal ” will appear.
l
Move mouse or hit any key on the keyboard
on the computer or activate video player, then access the OSD to set Audio to “ off ”
state.
No Input Signal when user
controls pressed
No picture, the LED light is green. When press “+”, “” or “Menu” key, the message “ No S-Video input
signal ”, “ No Composite input signal ” or “ No
Component input signal ” will appear.
l
Check the signal source. Make sure the
computer is not in power saving by moving
mouse or pressing any key on the keyboard.
Check to make sure Video Source to SVideo, Composite or Component is powered
and playing video media.
Check whether the signal cable is plugged in
and seated properly. Re-plug the signal cable
if necessary.
Re-boot the computer or video player.
l
l
l