Download Cornelius KIT CM450 User's Manual

IMI CORNELIUS INC.
One Cornelius Place
Anoka. MN 55303-6234
Telephone (800) 238--3600
Facsimile (612) 422--3246
INSTALLATION INSTRUCTIONS
KIT, P/N 2306
For installing Scotsman Model CM450, 500, & 650 Series Ice Makers on Remcort Model DB200 Series Ice/
Drink dispenser.
1. Bin Level Control
A.
Locate and drill three (3) 5/16”diameter holes (Ref. Fig. 1).
B.
Install mounting clamps.
2. Seal ice maker to top of Dispenser as follows:
A.
Run a bead of RTV on the dispenser cover around the outline of the ice maker and inside edge of cover opening.
B.
Set ice maker onto cover and install bin level thermostat capillary tube in clamps and tighten screws
(Ref. Fig 1). Position ice maker as shown.
C.
Wipe away excess RTV.
3. Secure ice maker to Dispenser with mounting brackets as show. Drill holes and install sheet metal screws
provided into ice maker cabinet and dispenser cover. Screws must not interfere with ice maker components.
4. Install adhesive backed gasket strip to removable lid, and install with screw provided.
5. Follow the manufacturer’s instructions to complete the installation of the ice maker. Bin level thermostat
capillary tube must not interfere with agitator.
91933
1
12/9/96
ROUTE ICEMAKER BIN LEVEL
THERMOSTAT CAPILLARY TUBE
AS SHOWN. INSTALL ON
HOPPER AS SHOWN IN FIG. 1
24
30
ICEMAKER TO BE
FLUSH WITH BACK
EDGE OF COVER.
APPLY RTV AROUND INSIDE
OF ICEMAKER OUTLINE ON
DISPENSER COVER TO
FORM A SEAL.
ADD ADHESIVE BACKED GASKET STRIPS TO REMOVABLE LID.
REMOVE SCREWS AND TURN
BRACKETS AROUND 180_.
REPLACE SCREWS. USING
BRACKET AS TEMPLATE,
DRILL (4) .136 DIA. HOLES
INTO ICEMAKER CABINET
FOR SHEET METAL SCREWS
PROVIDED. DRILLING IS NOT
TO INTERFERE WITH
ICEMAKER COMPONENTS.
28080
28080
REMOVABLE FRONT LID
FOR MANUAL ICE FILLING.
12/9/96
2
91933
ICEMAKER
TOPVIEW
FRONT WALL
OF HOPPER
THERMOSTAT
CAPILLARY TUBE
4--5/8
LOCATE AND ADD
CLAMP HOLE IF
NEEDED TO RETAIN
CAPILLARY TUBING
15”
1”
DRILL 5/16 DIA. HOLES FOR 8--32
WELD NUT
INSERT 8-32 WELL NUTS INTO 5/16
DIA. HOLES, TIGHTENING SCREWS
WILL SECURE
1--5/8
CAPILLARY TUBING
PLASTIC TUBING
USE AS REQUIRED
6
LARGE CLAMP
(IF NEEDED)
BIN LEVEL THERMOSTAT CAPILLARY
TUBING ASSEMBLY
91933
3
12/9/96