Transcript
TM INSTALLATION INSTRUCTIONS IMPORTANT: Read carefully before installing fixture. Retain for future reference. VISION WALL VWS/TB 2/17/04 IMI-435 WARNING: Make certain power is OFF before starting installation or attempting any maintenance. Thru-way Mounting Kit* 4.00 Wall Mounting Holes 1. The thru-way mounting kit is intended for use when a conduit run is surface mounted to a wall. It is designed to be used with 3/4-14 NPSL threaded conduit. 9.56 2. Install anchors (supplied by others) for 1/4" screws in the wall using hole pattern as shown (See Fig.1). 2.31 3. Install 1/4" teflon washers on mounting screw (supplied by others) and mount the thru-way box as shown (See Fig. 2). 4. Remove gasket backing and install as shown. 2.38 CL Conduit 5. Start two (2) 1/4-20 x 2.00 hex head cap screws, leaving approximately 1-3/8" under the head of the screws. 7.59 Fig. 1 1/4" Wall Anchor Screws (By Others) 1/4" Teflon Washer (2) Supplied 1/4 20 x 200 Hex HD Screws (2) (Fixture Mounting) 3/4 - 14 NPSL Conduit Run 1.19 2.38 Gasket (1) Supplied Shipped Loose *For Downward Mounting Only. Fig. 2 These instructions do not claim to cover all details or variations in the equipment, procedure, or process described, nor to provide directions for meeting every possible contingency during installation, operation or maintenance. When additional information is desired to satisfy a problem not covered sufficiently for user’s purpose, please contact your nearest representative. Customer First Center • 1121 Hwy 74 South • Peachtree City, GA 30269 IMI-435 AVU040292