Transcript
RETROSPECT COLLECTION® WASHSTAND FIRE CLAY/WOOD RETROSPECT COLLECTION® WASHSTAND • Retrospect Collection® pedestal top with period reproduction of classic dry sink wood washstand • Washstand/pedestal top with faucet holes on 8" (203mm) center • Turned leg detailing with lower drawer storage in White finish • Select hardwood solids construction • Right Height™ for greater comfort during use • Part of design matched Retrospect Collection ® Separate Components: ❏ 0282.008 Washstand/Pedestal top 8" (203mm) centers ❏ 9420.000 Washstand only Nominal Dimensions with Sink: 27" x 19-3/4" x 36" (686 x 502 x 914mm) 13-3/4" (349mm) Compliance Certifications Meets or Exceeds the Following Specifications: • ASME A112.19.9M for NonCeramic Fixtures • CAN/CSA B45 Series 3 Holes 1-3/8" (35mm) Dia. 8" (203mm) FINISHED WALL 3-3/8" (86mm) 9" (229mm) 15" (381mm) 19-3/4" (502mm) 1-3/4" DIA. STD. DRAIN OUTLET To Be Specified: ❏ Color: White only ❏ Recommended Faucet: 2373.701 ❏ Faucet Finish: ❏ Supplies: ❏ 1-1/4" Trap: 752683-495 ❏ P Trap Finish: 27" (686mm) FINISHED WALL 3/8" (10mm) DIA. SINK ANCHOR SCREW HOLES ON 13-3/4" (349mm) CENTERS 7-1/4" (184mm) 8" (203mm) 1-1/4 O.D. WASTE * 24" (610mm) * 22" (559mm) 1-1/4" O.D. TAILPIECE SUPPLIES AS REQ'D 36" (914mm) 13-1/2" (343mm) 7" (178mm) FINISHED FLOOR NOTES: DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND “P” TRAP ARE *SUGGESTED. ▼ ANCHOR SCREWS FOR LAVATORY AND PEDESTAL NOT INCLUDED. - FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY. PROVIDE SUITABLE REINFORCEMENT FOR ALL WALL SUPPORTS. IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances established by ANSI Standard A112.19.9M. These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided pages. © 2008 AS America Inc. I24 Revised 2/08
