Transcript
ENFIELD™ 2-PC ELONGATED TOILET VITREOUS CHINA ENFIELD™ 2-PC ELONGATED TOILET • Vitreous china • Low-consumption (6.0 Lpf/1.6 gpf) • Elongated siphon jet action bowl with 2” trapway • Rim height at 15” (381mm) • AquaForce flushing technology • Close-coupled tank with Satin Chrome finish top-mounted liftrod actuator • Includes solid hardwood seat with Satin Chrome hinges and solid hardwood decorative tank cap in either Maple or Cherry finish to match Enfield furniture • Internal trapway area fully glazed • 100% factory flush tested • Includes color-matched bolt caps ❏ ❏ ❏ 2860.330 Toilet complete with wood accessories in Cherry finish 2860.334 Toilet complete with wood accessories in Maple finish 2860.000 Toilet combination only without hardwood seat and tank cap ❏ ❏ ❏ ❏ 1 ± 1/4" (25 ± 6mm) 3311.016 Elongated Bowl only FINISHED WALL 29-3/4" (756mm) 8-7/8" (225mm) 4060.016 Tank complete with Satin Chrome finish lift rod actuator 9460.000 Tank rail trim, specify Cherry or Maple 5380.295 Solid maple hardwood seat, specify Cherry or Maple Color: ❏ White ❏ Linen ❏ Decorative toilet angle stop and supply 16-1/4" (413mm) 19-1/2" (495mm) 30-3/4" (781mm) 15-1/4" (387mm) " 8" (203mm) Compliance Certifications Meets or Exceeds the Following Specifications: • ASME A112.19.2M (and 19.6M) for Vitreous China Fixtures - includes Flush Performance, Ball Pass Diameter, Trap Seal Depth and all Dimensions ❏ C/L C/L OF SEAT POST MTG HOLES ON 5-1/2" (140mm) CTRS Nominal Dimensions: 29-3/4" x 21-1/4" x 30-3/4" (756 x 540 x 781mm) To Be Specified 21-1/4" (540mm) TANK TRIM 3/4" (13mm) 3-1/2" (89mm) 14-5/8" (371mm) 12" (305mm) 6-3/8" (162mm) C/L OF OUTLET AND TOILET MTG BOLTS 11-1/4" (286mm) FINISHED FLOOR " 6" (152mm) C/L OF SUPPLY AS REQUIRED NOTES: THIS COMBINATION IS DESIGNED TO ROUGH-IN AT A MINIMUM DIMENSION OF 305MM (12") FROM FINISHED WALL TO C/L OF OUTLET. DIMENSIONS SHOWN FOR LOCATION OF SUPPLY IS SUGGESTED. IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerance established by ANSI Standard A112.19.2 These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided pages. * in Satin finish SPS 2860 Revised 10/02 © 2002 American Standard Inc. TB-025