Download Lian Li PC-B25SB computer case

Installation Guide
Case components
140mm fan
120mm fan &
fan air duct
Patented
tool-less 5.25”
device mounting
Liquid-cooling
system tube vents
rubber cover
Patented
Tool-less PCI
add-on card holder
5.25" to 3.5"
convertor
Patented
HDD module
Patented
tool-less PSU
mounting bracket
Air inlet below PSU
with air filter
Hardware list
Buzzer (1)
Cable tie (2)
Screw (4)
for power supply mounting
Bracket(1)
for power supply mounting
Longer vision thumb screw(3)
for mother board mount
USB3.0 to USB2.0
convertor (1)
Screw (12)
spare parts
Rubber ring(24)
for HDD mounting
Fan air duct (1)
for fan mount
Thumb screw(24)
for HDD mounting
Shorter vision thumb screw(6)
for mother board mount
Side panels installation
PCI bracket (1)
Accessing fan filter
1
Slide the panel backward
to release.
Pull the front panel toward
yourself.
Remove the mounting bezel
ODD installation
Press the right and left side of the
bezel to remove.
Press plastic handle to release the
mounting bracket.
Push the ODD into the 5.25” rack,
close the bracket to secare the ODD
Press the handle to release
the washable air filter.
Left the top cover to remove.
Hard disk installation guide
!
!
!
Note:
For area where hard
to reach use the
long thumb screw
Secure the stand-off on the M/B tray
which match with the M/B fix points,
place the M/B on the stand-off fasten
with the thumb screws to secure.
Fasten four screws to the
HDD with anti-vibration
rubber rings.
Slide the HDD into the HDD
cage
Close the gate to secure the
HDD.
C50.B25S0.00E-1
PSU installation
Accessing filter
Place the PSU on the stand, and
push again to the rear panel.
Press the handle
to release the
washable air filter.
Lock the PSU bracket to secure
the PSU.
* For transportation, please use
screws to secure the PSU
Place the PSU bracket into
according slot as shown.
Fan air duct installation
Remove four thumb screws.
Place the fan air duct into proper
location, fasten four thumb screws.
Install air duct frame on fan with
four 5x10 screws.
PCI Add-on card installation
Loose the thumb screws in order to
adjust the angle .
Front panel cable
installation guide
1
2
GROUND
PWR
WHITE
POWER SW
GRAY
GROUND
Reset
PLED-
WHITE
BLUE
WHITE
NC
GREEN
PLED+
POWER
LED
IDE_LED- WHITE H.D.D LED
IDE_LED+ ORANGE
Speaker
Open the aluminum latch to
remove the PCI slot bracket.
RESET SW
Finish.
Push the card into the PCI slot,
close the aluminum latch to secure
the card.
+5V
I/O port installation
BLACK
NC
NC
RED
SPEAKER
PCI bracket installation
USB3.0
E-SATA
HD AUDIO
BLUE 10
BLACK PUEPLE 8
YELLOW 6
BROWN 4
RED 2
4
5
1
9
E-SATA
9
7
5
3
1
GREEN
KEY
ORANGE
N.C.
GND+H.S. TUBE
Access to rear I/O port.
USB3.0 to USB2.0 convertor
VCC
RED
D- WHITE
D+ GREEN
GND BLACK
RED
WHITE
GREEN
BLACK
KEY
VCC
DD+
GND
C50.B25S0.00E-2