Download Intel DH77EB

Product Description
1.4
System Memory
The board has four DIMM sockets and supports the following memory features:
•
•
•
•
1.5 V DDR3 SDRAM DIMMs with gold plated contacts, with the option to raise the
voltage to support higher performance DDR3 SDRAM DIMMs.
1.35 V Low Voltage DDR3 DIMMs (JEDEC specification)
Two independent memory channels with interleaved mode support
Unbuffered, single-sided or double-sided DIMMs with the following restriction:
Double-sided DIMMs with x16 organization are not supported.
•
•
•
•
•
32 GB maximum total system memory (with 4 Gb memory technology). Refer to
Section 2.1.1 on page 41 for information on the total amount of addressable
memory.
Minimum recommended total system memory: 1 GB
Non-ECC DIMMs
Serial Presence Detect
DDR3 1600 MHz, DDR3 1333 MHz, and DDR3 1066 MHz SDRAM DIMMs
Note: DDR3 1600 MHz DIMMs are only supported by 3rd generation Intel Core
processor family processors
•
XMP version 1.3 performance profile support for memory speeds up to 1600 MHz
NOTE
To be fully compliant with all applicable DDR SDRAM memory specifications, the board
should be populated with DIMMs that support the Serial Presence Detect (SPD) data
structure. This allows the BIOS to read the SPD data and program the chipset to
accurately configure memory settings for optimum performance. If non-SPD memory
is installed, the BIOS will attempt to correctly configure the memory settings, but
performance and reliability may be impacted or the DIMMs may not function under the
determined frequency.
Table 3 lists the supported DIMM configurations.
Table 3. Supported Memory Configurations
DIMM
Capacity
1024 MB
1024 MB
2048 MB
2048 MB
4096 MB
4096 MB
8192 MB
Note:
Configuration (Note)
SS
SS
DS
SS
DS
SS
DS
SDRAM
Density
1 Gbit
2 Gbit
1 Gbit
2 Gbit
2 Gbit
4 Gbit
4 Gbit
SDRAM Organization
Front-side/Back-side
128 M x8/empty
128 M x16/empty
128 M x8/128 M x8
128 M x16/empty
256 M x8/256 M x8
512 M x8/empty
512 M x8/512 M x8
Number of SDRAM
Devices
8
4
16
8
16
8
16
“DS” refers to double-sided memory modules (containing two rows of SDRAM) and “SS” refers to
single-sided memory modules (containing one row of SDRAM).
For information about…
Refer to:
Tested Memory
http://support.intel.com/support/motherboards/desktop/sb
/CS-025414.htm
19