Download E-flite EFL7150

EN
Box Contents
Quick Start Information
Transmitter
Setup
Dual Rates
Flight Timer
Setting
Set up your transmitter using the
transmitter setup chart.
High
Low
100%
70%
First flight 4 Min.
6 Min.
Specifications
Motor: BL10 Brushless outrunner
1250Kv
ESC: 40-Amp Lite Pro Switch
Mode BEC Brushless ESC (V2)
(EFLA1040LB)
TTable of Contents
Included
Installed
(4) Servos (EFLR7155)
Installed
Receiver: Spektrum™ AR636
6-Channel Sport Receiver
Installed
Battery: 2200mA 11.1V 3S 25C
Li-Po (EFLB22003S30)
Required to
Complete
Battery Charger: 3-cell Li-Po
battery balancing charger
Required to
Complete
Recommended Transmitter:
Full-Range 2.4GHz with
Spektrum™ DSM2®/DSMX®
technology. (DX4e and above)
Required to
Complete
42.5 in (1088mm)
45 in (1143mm)
51.0 oz
(1450 g)
539 sq in
(34.8 sq dm)
SAFE® Technology Flight Modes .........................................................4
Transmitter Setup for this SAFE® Technology Aircraft .........................5
Model Assembly ................................................................................6
Model Assembly Continued ................................................................7
Trimming ...........................................................................................8
Control Horn and Servo Arm Settings .................................................8
Transmitter and Receiver Binding.......................................................9
Battery Installation and ESC Arming .................................................10
Center of Gravity (CG) .....................................................................11
Control Direction Tests .....................................................................11
AS3X Control Direction Test ............................................................12
Flying Tips and Repairs ....................................................................13
Guidlines for Flying 3D .....................................................................14
Post Flight .......................................................................................14
Power Component Service ...............................................................15
Troubleshooting Guide SAFE ............................................................15
Troubleshooting Guide .....................................................................16
AMA National Model Aircraft Safety Code .........................................17
Limited Warranty .............................................................................18
Contact Information .........................................................................19
FCC Information ...............................................................................19
IC Information ..................................................................................19
Compliance Information for the European Union ...............................19
Replacement Parts...........................................................................70
Optional Parts ..................................................................................71
Preflight
1
Remove and inspect contents.
9
Make sure linkages move freely.
2
Read this instruction manual thoroughly.
10 Perform the Control Direction Test with the transmitter.
3
Charge flight battery.
11 Perform the AS3X Control Direction Test with the aircraft.
4
Setup Transmitter using transmitter setup chart.
12 Adjust flight controls and transmitter.
5
Fully assemble airplane.
13 Perform a radio system Range Test.
6
Install the flight battery in the aircraft (once it has been fully charged).
14 Find a safe open area to fly.
7
Check the Center of Gravity (CG).
15 Plan flight for flying field conditions.
8
Bind aircraft to your transmitter.
3