Download Chief PAC715-G
Transcript
INSTALLATION INSTRUCTIONS Instrucciones de instalación Installationsanleitung Instruções de Instalação Istruzioni di installazione Installatie-instructies Instructions d´installation Video Conferencing Shelf Spanish Product Description German Product Description Portuguese Product Description Italian Product Description Dutch Product Description French Product Description PAC715 PAC715 Installation Instructions DISCLAIMER WARNING: Failure to read, thoroughly understand, and Milestone AV Technologies and its affiliated corporations and subsidiaries (collectively "Milestone"), intend to make this manual accurate and complete. However, Milestone makes no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document. follow all instructions can result in serious personal injury, damage to equipment, or voiding of factory warranty! It is the installer’s responsibility to make sure all components are properly assembled and installed using the instructions provided. WARNING: Failure to provide adequate structural strength for this component can result in serious personal injury or damage to equipment! It is the installer’s responsibility to make sure the structure to which this component is attached can support five times the combined weight of all equipment. Reinforce the structure as required before installing the component. Chief® is a registered trademark of Milestone AV Technologies. All rights reserved. WARNING: Exceeding the weight capacity can result in IMPORTANT WARNINGS AND CAUTIONS! serious personal injury or damage to equipment! It is the installer’s responsibility to make sure the combined weight of all equipment and accessories mounted on the PAC715 does not exceed 10 lbs (4.54 kg). WARNING: A WARNING alerts you to the possibility of serious injury or death if you do not follow the instructions. CAUTION: A CAUTION alerts you to the possibility of damage or destruction of equipment if you do not follow the corresponding instructions. DIMENSIONS 228.6 9.00 174.6 6.88 82.6 3.25 222.8 8.77 28.6 1.125 INCREMENTS 6.8 0.27 260.9 10.27 3.2 0.125 228.6 9.00 48.3 1.90 222.8 8.77 369.8 14.56 215.2 8.47 110.1 4.33 2 25 0.98 MINIMUM EXTENSION MAXIMUM EXTENSION Installation Instructions PAC715 LEGEND Tighten Fastener Pencil Mark Apretar elemento de fijación Marcar con lápiz Befestigungsteil festziehen Stiftmarkierung Apertar fixador Marcar com lápis Serrare il fissaggio Segno a matita Bevestiging vastdraaien Potloodmerkteken Serrez les fixations Marquage au crayon Loosen Fastener Drill Hole Aflojar elemento de fijación Perforar Befestigungsteil lösen Bohrloch Desapertar fixador Fazer furo Allentare il fissaggio Praticare un foro Bevestiging losdraaien Gat boren Desserrez les fixations Percez un trou Phillips Screwdriver Adjust Destornillador Phillips Ajustar Kreuzschlitzschraubendreher Einstellen Chave de fendas Phillips Ajustar Cacciavite a stella Regolare Kruiskopschroevendraaier Afstellen Tournevis à pointe cruciforme Ajuster Open-Ended Wrench Remove Llave de boca Quitar Gabelschlüssel Entfernen Chave de bocas Remover Chiave a punte aperte Rimuovere Steeksleutel Verwijderen Clé à fourche Retirez By Hand Optional A mano Opcional Von Hand Optional Com a mão Opcional A mano Opzionale Met de hand Optie À la main En option Hex-Head Wrench Security Wrench Llave de cabeza hexagonal Llave de seguridad Sechskantschlüssel Sicherheitsschlüssel Chave de cabeça sextavada Chave de segurança Chiave esagonale Chiave di sicurezza Zeskantsleutel Veiligheidssleutel Clé à tête hexagonale Clé de sécurité 3 PAC715 Installation Instructions TOOLS REQUIRED FOR INSTALLATION #2 5/32" 1/4" PARTS B (2) 1/4-20 x 3/4" C (4) 1/4-20" A (1) [Video conferencing shelf] F (1) 1/4-20 x 3/8" D (1) [medium faceplate adapter] 4 Installation Instructions PAC715 Installation NOTE: The PAC715 video conferencing shelf can be mounted before or after the display is mounted to the faceplate. It may be mounted above or below the display if mounting to a large faceplate. It may only be mounted above the display if mounting to a medium faceplate. large faceplate Attach to Large Faceplate 1. Position video conferencing shelf (A) above or below the faceplate making sure to line up the holes on the shelf with the holes on the faceplate. (See Figure 1 or 2) 2. Install two 1/4-20 x 3/4" button head cap screws (B) through holes in shelf and faceplate. (See Figure 1 or 2) 3. Thread two 1/4-20" lock nuts onto screws to secure shelf to faceplate. (See Figure 1 or 2) 1 3 (B) x 2 2 (C) x 2 (A) (top installation) (A) (bottom installation) Figure 2 Attach to Medium Faceplate NOTE: The PAC715 may only be mounted above the display when mounting to a medium faceplate. 2 large faceplate (B) x 2 1. Use two 1/4-20" lock nuts (C) to secure medium faceplate adapter (D) to top or bottom of medium faceplate. (See Figure 3) 2. Thread two 1/4-20" lock nuts (C) onto screws to secure shelf to medium faceplate adapter (D). (See Figure 3) (A) 1 3 (C) x 2 2 Figure 1 (C) x 2 (D) 1 medium faceplate (C) x 2 Figure 3 5 PAC715 Installation Instructions Camera Mounting WARNING: Exceeding the weight capacity can result in serious personal injury or damage to equipment! It is the installer’s responsibility to make sure the combined weight of all equipment and accessories mounted on the PAC715 does not exceed 10 lbs (4.54 kg). 1 2 3 NOTE: Mounting options will vary depending on the type of camera being mounted. 1. Install 1/4-20 x 3/8" Phillips pan machine screw (F) through holes on shelf and into hole on bottom of camera. (See Figure 3) NOTE: Camera can be secured to mount by threading a tie through outside slots on camera mount and around the camera. NOTE: It is also acceptable to mount the camera directly to the shelf without any screws or ties. Figure 4 camera (example) 1 Shelf Extension Adjustment 1. Loosen two button head cap screws on video conferencing shelf (A). (See Figure 5) 2. Adjust shelf to desired mounting position. (See Figure 5) 3. Tighten two button head cap screws on shelf until mount is secure. (See Figure 5) (F) Adjustments Height Adjustment 1. Loosen two adjustment knobs on the back of the video conferencing shelf (A). (See Figure 4) 2. Raise or lower shelf to desired height. (See Figure 4) 3. Tighten two adjustment knobs on the back of the shelf until mount is secure. (See Figure 4) 1 2 3 Figure 5 6 Installation Instructions PAC715 7 PAC715 Installation Instructions USA/International Europe Chief Manufacturing, a products division of Milestone AV Technologies 8807-002000 Rev04 2012 Milestone AV Technologies, a Duchossois Group Company www.chiefmfg.com 07/12 Asia Pacific A P F A P F A 6436 City West Parkway, Eden Prairie, MN 55344 800.582.6480 / 952.225.6000 877.894.6918 / 952.894.6918 Franklinstraat 14, 6003 DK Weert, Netherlands +31 (0) 495 580 852 +31 (0) 495 580 845 Office No. 1 on 12/F, Shatin Galleria 18-24 Shan Mei Street Fotan, Shatin, Hong Kong P 852 2145 4099 F 852 2145 4477