Transcript
Installation Lithium-ion Battery Case for iPhone 5 Quick Start Guide 1. Pull the top of the battery case off. 3. Ensure the iPhone is well connected to the 8-pin connector. aluratek.com 2. Slide the iPhone 5 into the case. 4. Slide back the top of the case and click into place. APC02B qsg Q10304 Copyright © 2013 Aluratek, Inc. All Rights Reserved. Charging No need to take the iPhone out of the case. Simply use the included Micro USB cable and plug into any USB port on your computer or the orginal iPhone power adapter (not included). The LED’s located on the back of the device will blink when charging. The capacity is shown by the number of LED’s. When the case is powered on, the iPhone is charging and/or using the power from the case battery. If the iPhone is drained of power, the case will first charge your iPhone. If the iPhone is fully charged, the battery will drain from the case battery first before using the iPhone battery. To check the battery status, press the button located on the back of the case. Four LED’s means the case is fully charged, and one LED means it is almost empty. Tech Support & Warranty Information If you need further assistance, please contact the Aluratek support department for troubleshooting prior to returning this device. E-mail: [email protected] Web: www.aluratek.com/support Local (Tustin, CA): 714-586-8730 Toll free: 1-866-580-1978 Aluratek warrants this product against defect in material or workmanship for 1 Year from the date of purchase. For more information, please visit: http://aluratek.com/warranty-return-policy You can register your product online at: http://aluratek.com/product-registration