Download BlueWalker 10120561

Transcript
7. Trouble Shooting
If the UPS system does not operate correctly, first check the operating
information on the LCD display.
Please attempt to solve the problem using the table below. If the problem
still persists, consult your dealer.
7.1 Trouble Shooting According To Warning Indication
Problem Displayed
Possible cause
Remedy
EPO connector is closed
Check the EPO connector status
Maintain bypass switch
is open
Check the maintain bypass switch
status
Alarm code:11
Battery pack is not
connected correctly
Battery low
Battery voltage is low
Do the battery test to confirm.
Check the battery bank is
connected to the UPS.
Check the battery breaker is turn
on.
When audible alarm sounding
every second, battery is almost
empty.
Epo Active
Alarm code:71
On Maintain Bypass
Alarm code:72
Battery Disconnect
Alarm code:12
Output Overload
Overload
Check the loads and remove some
non-critical loads.
Check if some loads are failed.
Fan abnormal
Check if the fan is running
normally.
The charge fails
Consult dealer.
Battery is over charged
The UPS will turn off the charger
until the battery voltage is normal
UPS internal fault
Consult dealer.
Alarm code:41
Fan Failure
Alarm code:84
Charger Fail
Alarm code:15
Over Charge
Alarm code:14
Model Pin Error
Alarm code:92
51