Download V.I.O. POV.HD

POV.HD User Manual
Using the Recorder
Changing the Remote ID Channel - On the Remote Control
If you are using more than one POV.HD and/or POV.1.5 system in the same area, at the same time
you will need to adjust the Remote ID channel numbers that the wireless remotes are using to
communicate with the POV recorders so that each POV is using a different channel.
The remote control and POV recorder it is associated with must be set to the same channel in
order to work together, but must be different than other POV’s in use in the same area.
The Remote ID channel of the wireless remote is set using a small rotary dial located inside the
remote control. To adjust the channel you will need to open the remote control unit by removing
the four small Phillips screws at the four corners of the remote.
• Use a small flat bladed screwdriver to carefully rotate the pointer to the desired setting.
Take care to protect the inner workings of the remote from dust and moisture while the
cover is removed
• Replace the cover, tightening the four screws uniformly to create even pressure against
the seal
Changing the Remote ID Channel - On the POV.HD
To change the Remote ID Channel on the POV.HD,
• Go to Settings and locate Remote ID Channel.
• Set the Remote ID Channel to the channel number that the wireless remote has been
set to.
• Check the wireless remote to see that it is communicating correctly with the recorder.
See Check the Wireless Remote, above.
17