Download Benq Joybee GP2
Transcript
Operation Starting up the projector 1. Connect the power using the AC adapter. The Power LED indicator turns into blue and flashes slowly. 2. Press II Power on the projector or remote control to start the projector. The Power, OK and Ring LED indicators light blue when the projector is on. The start up procedure takes several seconds. In the later stage of start up, a startup logo is projected. (If necessary) Rotate the focus ring to adjust the image clearness. If the projector is activated for the first time, select your OSD language following the onscreen instructions. If you are prompted for a password, press the arrow keys to enter a six digit password. See "Utilizing the password function" on page 32 for details. Switch all of the connected equipment on. The projector will display the home screen. 3. 4. 5. 6. If the frequency/resolution of the input signal exceeds the projector's operating range, you will see the message 'Out of Range' displayed on a blank screen. Please change to an input signal which is compatible with the projector's resolution or set the input signal to a lower setting. See "Timing chart" on page 69 for details. Switching input signal The projector can be connected to multiple devices at the same time. However, it can only display one full screen at a time. Press / on the projector or remote control to select your desired input signal. • The input signal type effects the options available for the Picture Mode. See "Selecting the aspect ratio" on page 34 for details. • The native display resolution of this projector is in a 16:10 aspect ratio. For best display picture results, you should select and use an input signal which outputs at this resolution. Any other resolutions will be scaled by the projector depending upon the 'aspect ratio' setting, which may cause some image distortion or loss of picture clarity. See "Selecting the aspect ratio" on page 34 for details. Operation 29