Download Bogen AMT-12

Transcript
Example A
Daisy-Chaining Speakers
In these examples, pins 1+ and 1- on the Input
(Left) connector receive full-range audio from the
amplifier or from a previous speaker in a chain.
AMPLIFIER
The Parallel Input (Right) connector uses the
1+ and 1- pins to send full-range audio to the
Input connector of another speaker in a chain.
Loop-Thru connects all speakers in the chain in
parallel. Make sure the total impedance of the
chain is not less than what the amplifier is rated
to handle.
In Example A, the speakers are connected
with SpeakonTM connectors from the Amplifier
to Speaker 1, then from Speaker 1 to Speaker 2.
SPEAKER 2
SPEAKER 1
Input
Loop-thru
Example B
AMPLIFIER
In Example B, the speakers are connected
with the 1/4" Phone connectors from the Amplifier
to Speaker 1, then from Speaker 1 to Speaker 2.
SPEAKER 2
SPEAKER 1
When wiring the SpeakonTM connector, use
Pins 1+ and 1-. For the 1/4" Phone plug,
use Tip (+) and Sleeve (-). DO NOT wire more
than two speakers in parallel unless the amplifier
is rated for operation at less than 4 ohms.
Input
Loop-thru
Speaker Block Diagram
LF
HF
1+ : Phone Plug Tip and SpeakonTM Pin 1+
1- : Phone Plug Sleeve and SpeakonTM Pin 1PASSIVE CROSSOVER
+
Connector Wiring Diagram
(View from terminal side)
Wire like-named pins together to make loop-thru speaker cables.
1/4" Phone Plug
Tip (+)
1+
1-
1-
1+
-
SpeakonTM Plug
(not used)
Sleeve (-)
(not used)
4