Download Scali System Guide

Appendix D
ScaConf Reference
D-1 Installation and package dependencies
Installation of the Scali interconnect configuration system is normally handled by the
SSP install program, but the table below gives you a list of what to look for in case of
problems. Note that the ScaSH package must be installed on the frontend. .
Name
Description
ScaComd
Communication daemon (node)
ScaConfNd
Configuration daemon (node)
ScaConfSd
Configuration server (frontend)
ScaConfC
Scaconftool, ASCII based configuration tool
(frontend)
ScaSH
Parallel remote shell interface to nodes
(frontend)
Table 10-8: ScaConf packages
D-2 scaconftool - command reference
This section describes all available scaconftool commands and their syntax. The
<list> parameter is essential. <list> is to be replaced with a set of nodes. For
commands where a list of nodes are required, it is at least five different ways to state
these nodes. For further information about node selection, read section 7.3.2.3. <list>
is to be replaced by:
•
•
•
•
•
keyword all, meaning all nodes.
node state, meaning all nodes in this state (e.g OK, NO_DAEMON etc.)
list of node names separated by blanks, meaning all nodes explicitly listed.
left blank, meaning all nodes in internal list.
routing partition number, e.g. #1, meaning all nodes with this routing
partition number.
Scali System Guide Version 3.0
171