Download Submittal - Space Ray
Transcript
`` 2) MINIMUM CLEARANCES TO COMBUSTIBLES MINIMUM CLEARANCES TO COMBUSTIBLES Model No. LTS 40, 50 LTS 60, 75 LTS 80, 90 LTS 100 LTS 110, 120, 125, 130 LTS 140, 150 LTS 160, 175 LTS 180, 200 LTS 225, 250 Mounted Horizontally Angle Mounted at 45º Sides Ceiling* Below Ends 45º Front 45º Rear 24” 24” 26” 28” 32” 36” 42” 44” 56” 6” 6” 6” 6” 6” 6” 6” 6” 6” 40” 60” 66” 76” ** 82” ** 87” ** 93” ** 106” ** 112” ** 15” 15” 15” 15” 20” 20” 20” 20” 20” 40” 52” 52” 60” 66” 70” 77” 84” 90” 12” 12” 12” 12” 12” 12” 12” 12” 18” * When used indirect vented, minimum clearance for CEILING must be 12” for LTS 40-75 and 18” for LTS80-250. If optional corner and U-bend reflectors are not used, the clearance must be 18”. ** Maximum clearance below reduces to 72” once you are 20 ft. downstream from the control box. ▲ WARNING: Certain materials or objects, when stored under the heater, will be subjected to radiant heat and could be seriously damaged. Observe the Minimum Clearances to Combustibles listed in the manual and on the heater at all times. NOTE: 1. The clearances as specified above must be maintained to combustibles and other materials that may be damaged by temperature of 90°F above ambient temperature. Clearances to combustibles are posted on the control box. In areas used for storage of combustible materials where they may be stacked below the heater, NFPA54 requires that the installer must post signs that will “specify the maximum permissible stacking height to maintain the required clearances from the heater to combustibles”. Space-Ray recommends posting these signs adjacent to the heater thermostat or other suitable location that will provide enhanced visibility. 2. The stated clearance to combustibles represents a surface temperature of 90°F (32°C) above room temperature. Building materials with a low heat tolerance (such as plastics, vinyl siding, canvas, tri-ply, etc.) may be subject to degradation at lower temperatures. It is the installer’s responsibility to assure that adjacent materials are protected from degradation. Submittal♦LTS Jul-13