Download Outback - Pride Mobility Products

III. YOUR SCOOTER
Left and Right Turn Indicator Buttons
Use these buttons to turn on the left and right turn indicator (amber) lights. Press the appropriate turn
indicator button once to turn on the indicator light before turning your scooter. Your scooter’s turn indicators are timed to shut off automatically.
Electronic Controller Module (Not Shown)
This module is located on the scooter’s rear section, under the utility tray cover. The controller assembly
receives electrical signals from the console controls and sends power to the motor, the brakes, and the
lighting system.
NOTE: Only authorised Pride service personnel should ever remove the utility tray cover.
PROHIBITED! Do not expose the electronic controller module to moisture. If it does
become exposed to moisture, do not attempt to operate your scooter until it has dried
thoroughly.
Main Circuit Breaker (Reset Button)
When the voltage in your scooter’s batteries becomes low or your scooter is heavily strained because of
excessive loads, the main circuit breaker may trip to protect your scooter’s motor and electronics from
damage. See figure 6.
The main circuit breaker is mounted between the two batteries.
When the breaker trips, the entire electrical system of your scooter is shut down.
The main circuit breaker is designed to manually reset after one minute.
If the breaker trips frequently, you may need to charge your batteries more often or have your Pride
Provider perform a load test on your scooter’s batteries.
If the main circuit breaker trips repeatedly, see your authorised Pride Provider for service.
Battery Charger
The scooter comes with its own onboard battery charger. When the charger is plugged into an electrical
outlet, it charges the scooter’s batteries. See IV. “Batteries and Charging.”
BATTERY
CHARGER
MAIN CUIRCUIT
BREAKER
BATTERIES
Figure 6. Rear Section
Outback
www.pridemobility.com
21