Download Installation Instructions

Start-Up Procedures
e. Press the LEFT and RIGHT buttons to
adjust the firing rate from 0% to 100%.
Hold down the LEFT or RIGHT button to rapidly increase or decrease the
firing rate.
c
Measure Input - Natural Gas Only
1. Ensure the boiler is firing at maximum firing
rate. To manually place the boiler into high
fire mode, reference page 60.
2. Operate the unit for approximately 10
minutes.
Table 4: Recommended Combustion Levels
Natural Gas
Propane
3. Turn off all gas appliances within the building, except the PRESTIGE Solo.
O2 Min.
2.30%
2.70%
O2 Max.
5.30%
4.70%
4. At the gas meter, record the time required
to use one cubic foot of gas.
CO2 Min.
8.80%
10.70%
CO2 Max.
10.50%
12.00%
CO Max.
100 ppm
100 ppm
5. Calculate Natural gas input using the following equation:
3600 x 1000 / number of second recorded
for one cubic foot of gas = BTU/H.
6. The BTU/H calculated should approximate
the input rating listed on the unit.
f. Press the OK button while the FAN
icon is highlighted to shutdown the
burner.
g. Cycle power to the Prestige once combustion testing is complete to return to
normal operation.
WARNING
The combustion levels should be measured at high firing rate. If the combustion levels are not within the range given
in Table 4 for the firing rate, shut the
boiler down and contact Triangle Tube
Engineering Department. Failure to
comply with this requirement could
result in severe personal injury, death or
substantial property damage.
61