Download - PrintAbout

Printing Parameters
1. Z Resolution: Set the thickness of each printed layer. The lower
the value, the more details will be generated.
2. Part:
Angle: Determines the range of dense support generation.
Surface: Choose how many layers will be made for the bottom of
the model.
1
5
2
3. Support:
3
Dense: How many layers will be created for dense support
generation.
Space: Set the density of the support structure. The higher the
value, the less dense the supporting structure becomes.
4
Area: If the supporting area is less than this value, no support
will be generated.(You can turn off support by choosing "Only
Base.")
4. Stable Support: Generates more stable support. Using more
stable support can make it more difficult to remove from the
model.
5. Infill: The photo to the left shows the effects of the four different
infill options.
Shell
Surface
No infill in the
shell mode.
The model will
be printed
without the
bottom and top
layers. Only a
surface with a
single layer’s
thickness will be
made.
23