Download powermax1650

SETUP
Plasma gas supply
The gas supply for the Powermax1650 can be shop-compressed air or cylinder-compressed air. A
high-pressure regulator must be used on either type of supply and must be capable of delivering
gas to the filter on the power supply at 550 scfh/9.2 scfm (260 l/min), minimum flow rate, at a
minimum pressure of 90 psig (6.1 bar).
Note:
If the gas supply quality is poor, cut speeds decrease, cut quality deteriorates,
cutting thickness capability decreases, and parts life shortens.
WARNING
Do not allow the gas supply pressure to exceed 120 psi (8.3 bar). The filter bowl
may explode if this pressure is exceeded.
Additional gas filtration
Use Hypertherm filter kit (part number 128647) when site conditions introduce moisture, oil or
other particulates into the air line. A 3-stage coalescing filtration system, as shown, should be used
in extreme conditions.
Filter kit
128647
Gas supply
Powermax1650
OR
Water/particle filter
Gas supply
3-10
2
Oil filter
Oil vapor filter
Powermax1650
powermax1650 Operator Manual