1
Download Installation Manual
Transcript
Connecting MASTER Operator Step 3 GRN BRN ORG RED MASTER OPERATOR BLUE MASTER OPERATOR WHT Insert the stripped power cable wires into the appropriate terminals on the MASTER inputs terminal block. The green wire should be inserted into the GRN terminal, the white wire into WHT, the blue wire into BLUE, brown wire into BRN, orange wire into ORG, red wire into RED, and the black wire into the BLK terminal. BLK COM Master Power Cable COM SAFETY EXIT OPEN SHADOW LOOP CLOSE EDGE CONTROL INPUTS CYCLE CLOSE Tighten the set screws against the end of the wires. A dab of petroleum jelly on each terminal will help prevent corrosion. OPEN EDGE Wire Terminal Block Wire RECEIVER Terminal Block RED Wire Wrong BLK Wrong Correct RECEIVER together. Splicing permits corrosion and seriously degrades the wire's ability to carry an adequate current. GRN NEVER splice wires Terminal Block Connecting SECOND Operator PWR AUX RLY BRN ORG RED 2ND OPERATOR BLUE 2ND OPERATOR WHT BLK GRN BLUE BRN ORG RED MASTER OPERATOR WHT MASTER OPERATOR BLK COM Master Power Cable COM CONT CYCLE CLOSE Tighten the set screws against the end of the wires. LOCK GRN Insert the stripped wires of the power cable into the appropriate terminals on the SECOND inputs terminal block. The green wire should be inserted into the GRN terminal, the white wire into WHT, the blue wire into BLUE, brown wire into BRN, orange wire into ORG, red wire into RED, and the black wire into the BLK terminal. Second Power Cable AUX RLY Strip approximately 3/16" of insulation from each wire of the 50 foot power cable. Twist each exposed wire tightly. Insert the second opener power cable upward through the right strain relief (if necessary, loosen the sealing nut). Thread approximately 8" of wire into the control box. Retighten strain relief (on the black sheath of the power cable) until the power cable locks into place. LOCK PWR Step 4 GTO 4000XL/4200XL Instruction Manual © 082510 15
