Download Extreme Networks® Pluggable Interface Modules Installation Guide
Transcript
Removing an SFP Module LX100 SFP Module To prevent permanent damage to the LX100 SFP module, always check the optical input power of the receiver before you insert the fiber cable. The maximum optical input power is -9 dBm. If you use an optical loopback for diagnostics, the loopback requires a minimum of 12 dB optical attenuation. The recommended attenuation range is 12 to 20 dB. Removing an SFP Module To remove an SFP module: 1 Disconnect the optical cable from the SFP module. 2 Unlatch the SFP module in one of the following ways: ● On an SFP module similar to Module A in Figure 1, press and hold the black plastic tab at the bottom of the connector. ● On an SFP module similar to Module B, Module C, or Module D in Figure 1, rotate the front handle down. 3 Pull the SFP module out of the port on the switch. Extreme Networks Pluggable Interface Module Installation Guide 21