Download Consolidated Hardware Guide

Configuring I/O Modules
Figure 129: Showing the components and LEDs of the PoS module
Captive
retaining screw
Module status LED
Module diagnostics LED
Ejector/injector
handle
Network processors
and heat sinks
Network interface ports
Two on OC-12 PoS module
Four on OC-3 PoS module
Port status LED
(one per port)
Service ports
General Purpose Processor (GPP)
PoS_002
Software Requirements
The PoS modules require that you run ExtremeWare 7.0 or later on both the MSM module and the PoS
module, BootROM 7.8 for the MSM module, and BootROM 1.18 for the PoS module.
For more information about the software requirements, PoS module features, and PoS module
configurations, see the ExtremeWare Software User Guide and the ExtremeWare Command Reference Guide.
Hardware Requirements
The PoS modules are compatible with “i”series MSMs only. For the most current list of I/O modules
supported for use with the PoS modules, consult your release notes.
PoS modules installed in a BlackDiamond chassis require at least one BlackDiamond Ethernet I/O
module also installed in the chassis in order to operate correctly.
Extreme Networks Consolidated Hardware Guide
261