Download QuickSpecs

QuickSpecs
HP ProLiant DL140 Generation 2 (G2)
Technical Specifications
System Unit
Dimensions (HxWxD)
(with feet)
Weight (approximate)
Input Requirements
(per power supply)
1.70 x 16.78 x 26.75 in (4.32 x 42.62 x 67.95 cm)
35 lb (15.87 kg)
Fully configured
90 to 140 VAC/180 to 264 VAC
Range Input Voltage
115 or 230 VAC
Normal Line Voltage
Line Frequency
47 to 63 Hz
Rated Input Current load 7.1A at 115VAC, 3.6A at 230VAC
BTU Rating
BTU-Hr
2371
Power Supply Output
Rated Steady-State Power 500W
Power (per power supply) Maximum Peak Power
645W
Temperature Range
50° to 95° F (10° to 35° C)
Operating
-40° to 140° F (-40° to 60° C)
Shipping
Relative Humidity
10% to 85%
Operating
(non-condensing)
Non-operating
10% to 95%
Acoustic Noise
Idle (Fixed Disk Drives
Spinning)
6.31
L WAd (BELS)
Operating
(Random Seeks to Fixed
Disks)
6.32
L WAd (BELS)
NOTE: All temperature ratings shown are for sea level. An altitude derating of 1° C per 304.8 m (1.8°F
per 1,000 ft) to 3048 m (10,000 ft) is applicable. No direct sunlight allowed. Upper operating limit is
3,048m (10,000 ft) or 70 Kpa/10.1 psia. Upper non-operating limit is 9,144 m (30,000 ft) or
30.3KPa/4.4 psia. System performance may be reduced if operating with a fan fault or above 30C.
NOTE: Storage maximum humidity of 90% is based on a maximum temperature of 45° C (113° F).
Altitude maximum for storage corresponds to a pressure minimum of 70 KPa.
Non-Hot Plug SATA Hard 80 GB 7.2K
Drives
383410-B21
Capacity
Height
Width
Interface
Transfer Rate
Synchronous
(Maximum)
Seek Time
(typical reads, including
settling)
Physical Configuration
Operating Temperature
DA - 12205
80027 MB
1.028 in (2.61 cm)
4.0 in (10.16 cm)
SATA 150
150 MB/s
Single Track
0.8 ms
Average
9.0 ms
Full-Stroke
17.0 ms
Rotational Speed
7,200 rpm
Bytes/Sector
512
Logical Blocks
160,086,528
41° to 131° F (5° to 55° C)
Canada — Version 20 — September 29, 2006
Page 21