1
Download SoundStructure Design Guide - Support
Transcript
Enable Exit Tones For Telephony Interface—phone_exit_tone_en Argument Argument value Channel Type Virtual Channel Value Type Boolean Read/Write Mode Read/Write Phys Chans Analog Telephony Input, VoIP Telephony Input Virt Chans Mono Default 1 Event Source No Description This parameter enables or disables exit tone generation for the telephony interface. If exit tones are enabled (1), then an exit tone is played whenever the auto-hangup feature engages and disconnects the telephony interface. Entry tones (see the phone_entry_tone_en parameter) and exit tones are typically enabled to prevent a caller from entering or exiting a conference unannounced. Connect Or Disconnect Telephony Interface—phone_flash Argument Argument value Channel Type Virtual Channel Value Type Void Read/Write Mode Write-Only Phys Chans Analog Telephony Output Virt Chans Mono Event Source No Description Setting this parameter disconnects the telephony interface then reconnects it after a short delay. The amount of delay can be configured with the phone_flash_delay parameter. Polycom, Inc. 576
