Download DFI NB76-EA Motherboard

2
Hardware Installation
2.8.20 Wake-On-Ring Connector
1
2
Wake-On-Ring
(J12)
Pin
Function
1
Ground
2
RI#
The Wake-On-Ring connector is used to connect to an internal
modem add-in card that has the same connector. It will allow the
system that is in the Suspend mode or Soft Power Off mode to
wake-up/power-on to respond to calls coming through the internal
modem card.
To use this function, connect one end of the cable (that came with
the card) to the card’s wake-on-ring connector and the other end to
location J12 on the system board. You must also enable the “Resume
on Ring” field in the Power Management Setup of the BIOS.
If you are using an external modem, the ring-on function will come
through the serial port where the external modem is connected.
Important:
If you are using a modem add-in card, the 5VSB power source
of your power supply must support ≥720mA.
58