Download Canon 9350B001 Digital Camera User Manual

Lens Retraction Timing
The lens is normally retracted for safety about one minute after you press
the [
] button in Shooting mode (= 26). To have the lens retracted
immediately after you press the [
] button, set the retraction timing to
[0 sec.].
Power-Saving Adjustment
Adjust the timing of automatic camera and screen deactivation (Auto
Power Down and Display Off, respectively) as needed (= 27).
zzChoose [Power Saving], and then press
the [ ] button.
zzChoose [Lens Retraction], and then
choose [0 sec.].
Before Use
Basic Guide
Advanced Guide
zzAfter choosing an item, press the [ ][ ]
buttons to adjust it as needed.
●● To conserve battery power, you should normally choose [On] for
[Auto Power Down] and [1 min.] or less for [Display Off].
Using Eco Mode
This function allows you to conserve battery power in Shooting mode.
When the camera is not in use, the screen quickly darkens to reduce
battery consumption.
1 Configure the setting.
zzChoose [Eco Mode], and then choose
[On].
] is now shown on the shooting
zz[
screen (= 179).
zzThe screen darkens when the camera
is not used for approximately two
seconds; approximately ten seconds
after darkening, the screen turns off.
The camera turns off after approximately
three minutes of inactivity.
2 Shoot.
zzTo activate the screen and prepare for
shooting when the screen is off but the
lens is still out, press the shutter button
halfway.
●● The [Display Off] setting is applied even if you set [Auto Power
Down] to [Off].
●● These power-saving functions are not available when you have
set Eco mode (= 153) to [On].
Screen Brightness
Adjust screen brightness as follows.
zzChoose [LCD Brightness], and then
press the [ ][ ] buttons to adjust the
brightness.
1
Camera Basics
2
Auto Mode /
Hybrid Auto Mode
3
Other Shooting Modes
4
P Mode
5
Tv, Av, M, and C Mode
6
Playback Mode
7
Wi-Fi Functions
8
Setting Menu
9
Accessories
10
Appendix
Index
●● For maximum brightness, press and hold the [ ] button for at
least one second when the shooting screen is displayed or when in
single-image display. (This will override the [LCD Brightness] setting
on the [ ] tab.) To restore the original brightness, press and hold
the [ ] button again for at least one second or restart the camera.
153