Download Emerson MVME55006E Technical data
Transcript
Hardware Preparation and Installation 2.1 2 Overview This chapter provides unpacking instructions, hardware preparation, and installation instructions for the MVME761 transition module, the P2 adapter, and the Serial Interface Modules (SIMs). 2.2 Unpacking the Hardware The MVME761 is packed in an antistatic wrapper to protect it from static discharge. Emerson strongly recommends that you use an antistatic wrist strap and a conductive foam pad when handling the equipment. Electronic components can be extremely sensitive to electrostatic discharge (ESD). After removing the board from the protective wrapper, place it component side up on a grounded, static-free surface. Do not slide the board over any surface. Unpack the equipment from the shipping carton. Refer to the packing list and verify that all the items are present. Save the packing material for storing and reshipping of the equipment. 2.3 Installing the Serial Interface Modules Configure the serial ports 3 and 4 for the required interface by installing the appropriate SIM. See Table 1-1 on page 15 for a list of the serial port interface types. Prior to installing the SIMs, set the jumpers on header J2 (for serial port 3) and header J3 (for serial port 4) for either DCE or DTE. Set the jumper to position: z 1-2 if the SIM is for a DTE interface z 2-3 if the SIM is for a DCE Figure 2-1 1 2 DTE Serial Port Interface Jumper Setting 3 1 2 3 DCE MVME7616E Transition Module Installation and Use (6806800A43B) 19