Download MULTIQUIP GB2000 Specifications

Transcript
type 2 COMPONENTS (S/N g1900119 and above)
1. Lamp Fixture — Made of heat resistant polyester
balloon, with a diameter of 35.5 inches (902 mm) and
two 1000 watt metal halide lamps.
1
2. Locking Pin — Locks the lamp fixture in place when
attached to the pole on the bracket.
3. Balloon Power Cable — Provides AC power to the
lamps, fan and baloon inflation circuit.
4. Adapter Plate — Attaches to the T-Bar and mast
interface of the light tower to allow the GB2000 to be
installed.
NOTICE
Type 2 adapter plate fits most conventional light tower
masts.
5. Junction Box — Holds the electrical connection and
cables to connect the lamp fixture to the T-Bar and to
the power cable.
6. Support Bracket — Attaches to T-Bar to support
adapter plate (hardware not shown).
2
3
5
7. Connector Caps — Provides protection to the
receptacles on the junction box when not in use.
8. Fan Power Cable — 38 ft. (11.5 meters) cable that
provides 120 VAC from a GFCI receptacle (generator)
to the T-Bar mounted junction box to run the balloon
fan and inflate the balloon.
4
6
7
8
Figure 4. GB2000 Components
(Type 2 S/N G190019 And Above)
gb2000 balloon light• operation and parts manual — rev. #3 (08/30/12)— page 19