Download MULTIQUIP GB2000 Specifications
Transcript
type 2 COMPONENTS (S/N g1900119 and above) 1. Lamp Fixture — Made of heat resistant polyester balloon, with a diameter of 35.5 inches (902 mm) and two 1000 watt metal halide lamps. 1 2. Locking Pin — Locks the lamp fixture in place when attached to the pole on the bracket. 3. Balloon Power Cable — Provides AC power to the lamps, fan and baloon inflation circuit. 4. Adapter Plate — Attaches to the T-Bar and mast interface of the light tower to allow the GB2000 to be installed. NOTICE Type 2 adapter plate fits most conventional light tower masts. 5. Junction Box — Holds the electrical connection and cables to connect the lamp fixture to the T-Bar and to the power cable. 6. Support Bracket — Attaches to T-Bar to support adapter plate (hardware not shown). 2 3 5 7. Connector Caps — Provides protection to the receptacles on the junction box when not in use. 8. Fan Power Cable — 38 ft. (11.5 meters) cable that provides 120 VAC from a GFCI receptacle (generator) to the T-Bar mounted junction box to run the balloon fan and inflate the balloon. 4 6 7 8 Figure 4. GB2000 Components (Type 2 S/N G190019 And Above) gb2000 balloon light• operation and parts manual — rev. #3 (08/30/12)— page 19