Download Compaq 5500 Specifications
Transcript
2-10 Compaq ProLiant 5500 and 5500R Maintenance and Service Guide Top Access Panel The top access panel must be removed to access the I/O board. The access panel can be removed while the server is turned on without causing system shutdown, but auxiliary power (+5V) will remain in the exposed areas. WARNING: To reduce the risk of personal injury from hot surfaces, allow the internal system components to cool before touching them. CAUTION: To reduce the risk of server shutdown and subsequent data loss or damage to the equipment, use extreme care when running the server with the covers or access panels removed. Access panels are an integral part of the cooling system and removing them while the system is running may cause component stress or overheating. To remove the top access panel: 1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter. 2. Open the front bezel door (tower model only). 3. Use a Torx T-15 screwdriver to loosen the thumbscrew securing the top access panel to the front of the chassis. 4. Slide the top access panel back, then lift it from the chassis. Figure 2-5. Removing the top access panel Reverse steps 1 through 4 to replace the top access panel. For use with Pentium II and Pentium III Xeon processor-based servers only