Download Excalibur E951 Technical data

NEW EXCALIBUR
•
Put liquid PTFE on the first two turns(P31) and (P32) to avoid
the two components coupled as shown from unscrewing.
•
Make the piston stem (P19) fitted previously complete a full
stroke as shown.
English
P19
P32
P31
•
Use the pin (P12) supplied to tighten the gasket compression
ring nut (P11).
Close this until it is fully touching, without forcing.
P11
P12
•
Use a 36 mm spanner to screw on the pump unit (P10).
P10
CORRECT POSITIONING OF THE PUMP UNIT
Once the unit has been refitted, proceed as follows:
29
•
Check the position of the con rod, which should be positioned
at its lower stopping point.
•
Put the entire pump unit (P10) inside the reduction cover
(P33) as shown.