Download Enterasys VHSIM2-A6DP User`s guide

Access Control List Screen
4. Repeat steps 1 through 3 if more than one range of addresses is being entered. Up to 16 ranges
of IP addresses, including any single IP Addresses entered. If an invalid format is used to enter
an IP address, one of the following messages may display in the Event Message Line:
• “INVALID IP FORMAT” if more than 3 periods are used,
• “INVALID IP” if numbers > 255 are used.
• “DUPLICATE IP” if the same IP is entered.
• “INTERNAL IP” if the module’s IP is entered.
Then the field returns to 0.0.0.0.
5. Use the arrow keys to highlight the Access Control Lists field.
6. Press the SPACE bar to toggle the field to ENABLED.
7. Press ENTER.
8. Use the arrow keys to highlight the SAVE command and press ENTER. The message “SAVED
OK” displays on the screen.
NOTE: Exiting without saving causes a “NOT SAVED?” message to display above the
SAVE command. Edits are lost if they are not saved before exiting.
The designated devices associated with the range of IP addresses in the ACL will now have remote
access to Local Management. Access to Local Management using the COM port is not affected.
5.6.2
Enable/Disable ACL
To just enable or disable ACL, proceed as follows:
1. Use the arrow keys to highlight the Access Control Lists field.
2. Press the SPACE bar to toggle the field to either ENABLED or DISABLED.
3. Press ENTER.
4. Use the arrow keys to highlight the SAVE command and press ENTER. The message “SAVED
OK” displays on the screen.
NOTE: Exiting without saving causes a “NOT SAVED?” message to display above the
SAVE command. Edits are lost if they are not saved before exiting.
Module Configuration Menu Screens
5-29