Download Savin 3360DNP Operating instructions

Operation
Skip Feed Printing
You can increase the time between
prints using the {Skip Feed}
} key. By default, when one sheet of paper is fed,
the drum rotates twice. However, you
can select the number of drum rotations. This gives you a chance to remove prints one by one from the
paper delivery tray or insert one sheet
of paper between two prints. If you
use this function, you can also use paper longer than the length limitation
of 432mm, 17.0".
1
Note
❒ For every sheet of paper fed, the
drum rotates twice by default. You
can change this default setting
with the user tools. See “No. of
Skip Feed” on p.144 “4. Mode Setting”.
❒ The maximum length of paper in
Skip Feed mode is 460mm, 18.1".
❒ When you use paper longer than
432mm, 17.0", prints will not be delivered to the paper delivery tray
properly, so lower the paper delivery end plate and take out the
prints by hand.
A Place your original on the expo-
sure glass or in the optional document feeder.
B Press the {Skip Feed}} key.
Stamp
Image Density
Lighter
On Line
Normal
Darker 1
Skip Feed
Make-Up
Darker 2
Over lay
Economy Mode
Edge Erase
Original Storage
Auto On Line
Job Separator
ZDZS030N
70
C If necessary select the number of
drum rotations per sheet of paper
fed with the [←
←] [→
→] or {~} {}}
keys.
Note
❒ You can also select the number
of rotations with the number
keys.
❒ You can select from 2 to 9 rotations.
❒ By default, the machine asks
you to confirm the number of
rotations. You can have this step
omitted by adjusting the user
tool settings. See “No. of Skip
Feed” on p.144 “4. Mode Setting”.
D Press the [OK] key.
E Press the {Start}} key.