Download Schneider Electric Xantrex XW Installation guide

Safety
Personal Protection
Follow these instructions to help protect yourself while working with the charge
controller.
DANGER
HAZARD OF ELECTRIC SHOCK AND BURN
Thoroughly inspect the charge controller prior to energizing. Verify that no
tools or materials have been inadvertently left behind.
Failure to follow these instructions will result in death or serious injury.
Installation personnel must be equipped with adequately rated personal
protective equipment as per local safety regulations and applicable workplace
safety procedures.
Battery Safety Information
DANGER
HAZARD OF ELECTRIC SHOCK, BURN, FIRE, AND EXPLOSION
Batteries contain corrosive electrolyte and can give off explosive gases.
Battery circuits present a shock and energy hazard. Observe proper
precautions when working with batteries and battery circuits, including:
• Always wear eye protection when working with batteries.
• Remove all jewelry before performing electrical work.
• Install batteries in a well-ventilated area to help prevent the possible
buildup of explosive gases.
• Do not mix battery types.
• Do not smoke in the vicinity of a battery.
• Use insulated tools when working with batteries.
• When connecting batteries, always verify proper voltage and polarity.
• Do not short-circuit the battery.
• Always use proper lifting techniques when handling batteries.
Failure to follow these instructions will result in death or serious injury.
For full installation instructions and safety information, see the documentation
provided with the batteries. Consult the MSDS for the batteries for first aid
procedures, emergency procedures, and clean-up instructions.
viii
975-0540-01-01 Revision B
This guide is for use by qualified personnel only.