Download Merit 710T User`s guide

Transcript
INTRODUCTION
INTRODUCTION
P R E - A S S E M B LY
ASSEMBLY STEP 2
note: During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before
HARDWARE BAG 2 CONTENTS :
SPRING WASHER (B) 15.4 mm Qty: 4
BOLT (A) 25 mm Qty: 4
HARDWARE BAG 1 CONTENTS :
IMPORTANT
PRECAUTIONS
A S S E M B LY S T E P 1
ARC WASHER (C) 17 mm Qty: 4
A Open HARDWARE BAG 2.
ASSEMBLY
BOLT (A) 15 mm Qty: 8
B Attach the CONSOLE to the
UPRIGHT MAST using 2 BOLTS
(A), 2 SPRING WASHERS (B), and
2 ARC WASHERS (C).
FLAT WASHER (C) 15.5 mm Qty: 4
C Repeat on the other side.
BEFORE
YOU BEGIN
BEFORE
YOU BEGIN
CONSOLE
SPRING WASHER (B) 15.4 mm Qty: 8
ASSEMBLY
IMPORTANT
PRECAUTIONS
completely tightening any ONE bolt. NOTE: A light application of grease may aid in the installation of hardware.
Any grease, such as lithium bike grease is recommended.
ARC WASHER (D) 17 mm Qty: 4
ARC WASHER (C)
SPRING WASHER (B)
BOLT (A)
CONDITIONING
GUIDELINES
ARC WASHER (D)
CONSOLE MAST SUPPORT TUBE
FLAT WASHER (C)
BOLT (A)
TREADMILL
OPERATION
TREADMILL
OPERATION
CONSOLE MAST
CONSOLE WIRE
B Slide the right CONSOLE MAST
down on to the CONSOLE MAST
SUPPORT TUBE. On the front
of the CONSOLE MAST, bolt
in place using 2 BOLTS (A), 2
SPRING WASHERS (B), and 2
ARC WASHERS (D). On the side of
the CONSOLE MAST, bolt in place
using 2 BOLTS (A), 2 SPRING
WASHERS (B), and 2 FLAT
WASHERS (C).
SPRING WASHER (B)
UPRIGHT MAST
* Note: Be careful not to pinch any wires while assembling the masts.
CONDITIONING
GUIDELINES
A Open HARDWARE BAG 1.
SPRING WASHER (B)
TROUBLESHOOTING
& MAINTENANCE
TROUBLESHOOTING
& MAINTENANCE
C Repeat on other side.
D On right side thread CONSOLE
MAST WIRE through CONSOLE
MAST.
LIMITED
WARRANTY
710T_Rev.1.7.indd 8-9
LIMITED
WARRANTY
BOLT (A)
11/30/07 10:07:52 AM