Download Merit 710T User`s guide
Transcript
INTRODUCTION INTRODUCTION P R E - A S S E M B LY ASSEMBLY STEP 2 note: During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before HARDWARE BAG 2 CONTENTS : SPRING WASHER (B) 15.4 mm Qty: 4 BOLT (A) 25 mm Qty: 4 HARDWARE BAG 1 CONTENTS : IMPORTANT PRECAUTIONS A S S E M B LY S T E P 1 ARC WASHER (C) 17 mm Qty: 4 A Open HARDWARE BAG 2. ASSEMBLY BOLT (A) 15 mm Qty: 8 B Attach the CONSOLE to the UPRIGHT MAST using 2 BOLTS (A), 2 SPRING WASHERS (B), and 2 ARC WASHERS (C). FLAT WASHER (C) 15.5 mm Qty: 4 C Repeat on the other side. BEFORE YOU BEGIN BEFORE YOU BEGIN CONSOLE SPRING WASHER (B) 15.4 mm Qty: 8 ASSEMBLY IMPORTANT PRECAUTIONS completely tightening any ONE bolt. NOTE: A light application of grease may aid in the installation of hardware. Any grease, such as lithium bike grease is recommended. ARC WASHER (D) 17 mm Qty: 4 ARC WASHER (C) SPRING WASHER (B) BOLT (A) CONDITIONING GUIDELINES ARC WASHER (D) CONSOLE MAST SUPPORT TUBE FLAT WASHER (C) BOLT (A) TREADMILL OPERATION TREADMILL OPERATION CONSOLE MAST CONSOLE WIRE B Slide the right CONSOLE MAST down on to the CONSOLE MAST SUPPORT TUBE. On the front of the CONSOLE MAST, bolt in place using 2 BOLTS (A), 2 SPRING WASHERS (B), and 2 ARC WASHERS (D). On the side of the CONSOLE MAST, bolt in place using 2 BOLTS (A), 2 SPRING WASHERS (B), and 2 FLAT WASHERS (C). SPRING WASHER (B) UPRIGHT MAST * Note: Be careful not to pinch any wires while assembling the masts. CONDITIONING GUIDELINES A Open HARDWARE BAG 1. SPRING WASHER (B) TROUBLESHOOTING & MAINTENANCE TROUBLESHOOTING & MAINTENANCE C Repeat on other side. D On right side thread CONSOLE MAST WIRE through CONSOLE MAST. LIMITED WARRANTY 710T_Rev.1.7.indd 8-9 LIMITED WARRANTY BOLT (A) 11/30/07 10:07:52 AM